HOBBYKING SS SERIES 25-30A ESC THROTTLE RANGE

Rest assured though that before I recorded the video I had performed the same steps but fully unplugged. Already have an account? All did the things. So will swap out all elements until I work out which is at fault hopefully it is not me that is at fault! Find More Posts by dogwood Still learning with the cub but looking forwards to Friday.

I have had very good luck with the Turnigy Plush series up to 80amp. All did the things. So I don’t think it is indicating I am in bind mode but something else. I put a 3S on it and got the same beep sequence. Find More Posts by Gary L. Yeah i was looking at those but theyre out of stock! Oddly the motor did kick into life yesterday when I was trying the setup for the millionth time. Find More Posts by gramps

Ya ubec is the safe way to go. Even when you turn your Tx back on ,,,the Rx will still flash but slower to let you know that it had lost it’s bind. Still learning with the cub but looking forwards to Friday.

Sign in Already have an account? The following errors occurred hobbying your submission. So this problem is fixed by going through the programming sequence until you get to the “default parameter” and then lower the throttle all the way.

Posting Quick Reply – Please Wait. Sign In or Sign Up. I can’t set the throttle range, and get very low power. Sign In Sign Wsc.

  CJHK EEEAA 2 EPISODE 004 PART 4

Last edited by Thorttle at The Turnigys are of course the easiest with the cheap little programming card they sell. Range going to be ok? Mode II The control stick configuration with the ailerons and elevator being controlled by the right stick while the left stick controls the rudder and throttle.

Hobbyking SS Series 190-200A ESC

Find More Posts by gramps The last 2 I have used only lasted about 2 months each, and that’s not with a lot of use. Ya Hobbykinh noticed the bind light was flashing to but it was def bound.

I have a 2S lipo and I get that with the throttle on full or on idle! Originally Posted by Live2Fly.

Already have an account? Dont rush your build take your time, you will enjoy the flights more as you know the amount of time and effort you spent in getting bird airworthy.

Jan 08, No kids, peace and quiet and plenty of time to spend getting the bixler assembled. The low voltage cutoff also fails to work if your system is pulling low amps. Quote message in reply?

Good to have a spare then I can swap bits out until I find out where the issue lies. Rest assured though that before I recorded the video I had performed the same steps but fully unplugged. Jan 16, Hopefully the issue is not with the receiver cos I don’t have a spare one of those. Sean Edited April 24, by seanmcgrath Posted April 24, Power Systems Talk about motors, ESC speed controllers, gear drives, propellers, power system simulators and all power system related topics.

  YAARIYAN MOVIE ENCYCLOPEDIA

Use of this site indicates your consent to the Terms of Use. The problem is if you power up your ESC with the throttle NOT all the way down, you can start the programming sequence.

No throttle from SS A ESC, radio seems to bind ok. Any ideas? – Helicopters – MSUK RC Forum

A program-card is a good investment! Find More Posts by Radbuster.

Nano tech ‘s and rhino s. There’re a couple of tutorials on Youtube and a great explanation of multirotor settings for ESC when using a programing card on oddcopter.

This shows up because you get the arm-tone 3 beeps for 3 cell lipo and a slur-up note yet the motor will not run. Again, thanks for the info. Oddly the motor did kick into life yesterday when I was trying the setup for 253-0a millionth time.

Author: admin